LEADERS IN INNOVATIVE TECHNOLOGY SOLUTIONS
Facebook LinkedIn YouTube

Researchers at the Georgia Tech Research Institute’s Food Processing Technology Division and the University of Georgia’s Tifton campus are collaborating on the design, fabrication, and deployment of a low-cost robot arm that is more than 80 percent 3D-printed from plastic. The targeted first application is inspecting bell pepper leaves for the early detection of pests, for which the robot arm will be mounted onto one of UGA’s autonomous rovers that is capable of navigating up and down the rows of a crop field.

 

One intent of the project is to demonstrate the efficacy of using consumer-level 3D printing technology for an application that requires both precision and repeatability. Due to the particular geometry of the rover and the layout of the bell pepper plantings, the reach of the arm is about 5 feet measured from its anchor point on the rover. The payload, consisting of a suite of sensors, will be approximately 2 pounds.

 

Two challenges result from the design parameters of this application: (1) the long reach of the robot arm, made mostly from relatively flexible plastic, can lead to imprecision and vibrations during motion control, and (2) a 2-pound payload cantilevered several feet represents a significant weight to support.

 

To address the first challenge, the researchers are applying visual servoing, which is a method to control a robot arm using a camera as feedback. The control method closely resembles the way a human senses and manipulates objects. In the same way that people can manipulate (approach and grasp) everyday things without having to know the measurements of their arms and hands, robots implementing visual servoing control do not require precise or even known hardware geometries. This is a benefit in the case of the GTRI-UGA 3D-printed robot, where the relative lack in structural rigidity leads to difficult-to-characterize, or even changing, hardware geometries of the arm.

 

Regarding the second challenge, researchers are learning how to build with plastic and have devised a novel cam counterbalance mechanism that can support weight passively (with springs), such that actuation (applied by motors) is not needed to overcome gravity, but only during actual arm movement. The ability provided by the 3D printer to fabricate endlessly inventive cam shapes made it feasible to implement the counterbalance in a cost-effective way.

 

The research team plans to deploy the robot arm/autonomous rover for inspection tasks in the bell pepper fields in Tifton, Ga., during next year’s spring planting.

 

 

Project Contact: Ai-Ping Hu

 

 

3D-Printed Robot Arm for Crop Inspection

3D-printed, low-cost robot arm mounted onto the UGA autonomous rover for bell pepper plant inspection.